How do I pair my monster smart LED lights?
1: Press and hold the pairing button on the device and ensure that the LED indicator is now blinking RAPIDLY. 2: Open the Monster Smart app. From the add device list, click on Lighting (WiFi). 3: Follow the on-screen instructions to confirm that the LED indicator is rapidly blinking.
How do I reset my monster LED light?
Just open up your monster smart app and select the LED strips from the home screen. From there you need to go into device settings and click on the reset option. After that just wait a few seconds while your LED strips reset.
Why can’t I connect to my LED lights?
Bad Pin Connection If your LED strip light fails to turn on at all, then check your pin connections. Most likely, the pin is not inserted correctly. In rare cases, the pin is faulty. These tiny connectors are rather delicate items so you have to be very careful when inserting them.
How do I sync my LED lights to my phone?
How to Use Smart LED Strip Lights with EZ Mode
- Step 1: Download LampUX App. Android and iOS users can go to the App store and download LampUX App on your phone, then register an account.
- Step 2: Set Up the Smart LED Light Strip. Turn on the LED strip lights and wait for 10 seconds.
- Step 3: Connect the App.
Why are my monster LED lights flashing?
When you overload your power supply by drawing too much wattage from the output, your LED strip lights will begin to flash in a consistent pattern.To avoid this, always check the total wattage that the power supply can handle and make sure the total wattage of the LED strips is less than that number.
How do I pair my RF LED remote?
To pair the remote, remove power from the controller for 5 seconds. Re-apply power to controller and within 5 seconds, press and hold 100% and 25% buttons for 5 seconds. Up to three remotes can be paired to a controller.
Why won’t my LED lights connect to Bluetooth?
Try to reset the light strip. Reset: Press the middle button on the control box for four times while holding the power button.Please try to unplug the light strip for 10 mins, then re-plug it.
How do I reset my LED strip WIFI?
press and hold the power button of wifi led controller for 5-6 seconds , then you can reset the light strip controller again.
What do you do if your LED lights don’t work?
If your LED light source does not work properly, you can remove it from the lamp and try it out in another lamp with the same socket. In the best case, this lamp should be connected to another circuit.
What app do you get for your LED lights?
What is Lumenplay®? Lumenplay® is an extendable string of app-enabled RGB LED lights that enables you to create scenes of color and motion, all from your smart device. Use the free Lumenplay® app to setup a personalized light show by choosing color combinations, effects, speed, direction and brightness.
What is the app for Nexillumi?
?Phone App Control & Remote Control??Enjoying the lights ambience mood lighting with your smart phone by downloading our Free App “Happy Lighting” at Google Play or IOS APP Store ? Convenient 24 Key Remote control while your phone is not near you.
Why are my LED lights blinking red?
Your LED strip lights might be flickering because of fluctuations in voltage. All electrical appliances, including strip lights, need a constant voltage supply to work smoothly. If the voltage drops for any reason, the entire length of the strip will flicker, and its brightness will decrease.
How do you make LED lights flash red and blue?
LED Strip – Solid Red the whole strip for 3 seconds, flash to a very very light blue (almost white) for about a half a second, back to red for about a half a second, back to the light blue/white for a half a second, and repeat.
How do you fix LED strips that won’t turn on?
Check for any visible loose connections, make sure all of your connectors and wires are in place and have not fallen out. Try tightening screws on DC adapters, and re-inserting LED strips into solderless connectors, which are common contact failure points.
Contents