Where Is My Schlage Programming Code?

The default programming code is printed on a label on the programming guide that came with your lock. If you do not have access to the guide, remove the lock from the door and look on the back of the lock for a label containing the default code.

Where is the master code on a Schlage Lock?

Schlage Keypad Locks
If you take the lock off of the door you will find the master code on a sticker on the back of the front of the lock. It is put there for security purposes as it requires you to have the access and ability to remove the lock from the door. The sticker will have three codes on it.

What do I do if I lost my Schlage programming code?

In fact, if you’ve lost your Programming Code, you can reset the lock and then use the default Programming Code to reprogram it. Note that after performing a factory reset, all previous programming will be erased/returned to factory default settings.

What is the Schlage default user code?

BE365
Note: This 4-digit code is your User Code that can be used to unlock the lock. You can add more User Codes with the same process—the lock stores up to 19 User Codes. Now, that’s all about changing the default 4-digit code on your Schlage lock BE365.

How do you reprogram a Schlage lock without the code?

So first how to Reset Schlage Keypad lock?

1. Disconnect the batteries.
2. Press and hold the Outside Schlage Button.
3. While holding the Outside Schlage Button, Reconnect the batteries.
4. Release the Outside Schlage Button.
5. To check that the lock was reset, press the Outside Schlage Button and enter one of the Default User.

How do you put the 4 digit code on a Schlage Lock?

How to Add a Code to a Schlage Entry Lock

1. Enter the six-digit programming code found in your lock’s manual into the lock’s keypad.
2. Press the button located at the top of your lock.
3. Press “1” on the keypad.
4. Enter the new four-digit code you want to use.
5. Re-enter the four-digit code to confirm the code. Warning.

How do I change the 4 digit code on my TRU bolt lock?

So, here’s how to change the preset Programming Code on a Tru-Bolt electronic lock:

1. Step 1: Enter the preset Programming Code (123456) and press the Unlock button.
2. Step 2: Press 4 and then press the Unlock button.
3. Step 3: Enter your new Programming Code and then press the Unlock button.

How do I connect my phone to Schlage?

To pair your Schlage Connect Smart Deadbolt with Samsung SmartThings, open the SmartThings app on your mobile device and tap on Home. Under Things, choose Add a Thing and follow the directions in the app. At the end of enrollment, a green light on your lock indicates success.

Why is my TRU bolt lock beeping?

If your Electronic Door Lock is beeping and the buttons are flashing red, this means that there’s been some kind of error or the batteries are low. If the batteries have already been changed and you still see a red flashing light when you try to use the lock, there could be an error with the lock.

How do you rekey a TRU bolt lock?

Tru Bolt locks may use a keyway similar to Kwikset, but as far as I know, they do not have or use the smart key system. The only way to rekey them is a locksmith or buy a new tumbler kit and re-key your self.

How do I know my Schlage Lock?

Look on your Schlage key. It should have 5 pin numbers stamped on the the back of the key with the letter C below the numbers.