So, what is the best trolling speed? The best trolling speed depends on several factors including the type of fish, water conditions and lure choice. In general, trolling speeds between 1.5 and 2.5 mph, as measured by GPS, are a good starting place for most species like
What is a good trolling speed for bass?
It takes a bit of experimenting to get the speed right, but for typical bass crankbaits it’s anywhere from 2 to 4 mph–you can tell prime speed because that’s where the rod bows up most.
How fast should you troll in the ocean?
“Any [speed] faster than 10 knots, [and] you typically have to fish with trolling weights and wire line in order to keep the baits down below the surface,” says Impson. Wahoo are one species that truly excels at those high trolling speeds. Ten to 12 knots is no problem for a trolling speed for wahoo.
Does trolling speed affect lure depth?
Speed (at normal trolling speeds) isn’t supposed to noticeably affect the depths of cranks when long lining and that’s why you see no depth compensation curves for different speeds.
What is the best trolling speed for walleyes?
What Speed Should You Troll For Walleye? It depends on the time of year and water temperatures. Trolling speed, in the spring, is best at 1.3 – 1.5 mph. Summer trolling speeds increase 1.5- 2 mph as walleyes are more active in warmer water temperatures.
How much line should I let out for a troll?
Downriggers. Downriggers allow for extra long length between the downrigger ball and the lure. Let out 50 feet of line and clip into the release. If that’s not enough distance to prevent your lake’s wary walleyes from seeing the ball…then let out 150 feet of line!
How far offshore can you troll?
Proper distance for most boats will be anywhere from 20 feet to 150 feet behind your boat. Whether you have inboard diesel or outboard gas engines, your power dictates the distance you troll your baits and lures.
Is mono or braid better for trolling?
Mono holds knots better and costs less than braid. It also works better on smaller bait-casting reels because light braid can dig into itself. Florida sailfish and dolphin anglers still use a lot of mono on the troll, and some use it for kite lines because it runs through the clips better.
What is the best speed to troll for mackerel?
The secret to more effective Mackerel trolling is speed. If you want to catch more Mackerel on lures, troll faster. While 6 knots is okay, 7, 8, 9 or 10 knots is even better. The faster you can troll, the more likely you are to get connected.
How do I make my lures deeper when trolling?
If you need to go deeper, just let out some backing until your target depth is reached. On the lure end of the line, remove a short section of lead as before and tie on a size 18, or smaller, barrel swivel. Now use a 10 to 15 foot mono or fluorocarbon leader to tie on the lure.
How deep do Thunderstick JR dive?
6 – 15 ft
The injured baitfish swimming action of this lure attracts fish of all species. Depth: 6 – 15 ft.
How fast do you pull crankbaits?
Determine a depth – Like Whitehead, using 90 to 110 feet of line is a good starting point. At 1.5 mph this will put the 8- to 12-foot crankbaits between 12-16 feet, depending on wind on waves. Choose a speed – 1.5 to 1.7 mph is where Whitehead stays and is a common speed for pulling cranks.
How fast can you troll crawler harnesses?
The best trolling speed for fishing with a crawler harness is from 1 to 1.4 mph. This is significantly slower than most other baits used in the summer, and the reason for this is that you don’t want to rip off your nightcrawler from the harness by trolling at high speeds.
Can you troll with a crankbait?
Trolling with crankbaits is a good time. In this link, walleye expert, Dale Gilbert, explains his setup and a technique that he uses to make sure lures are tuned.
Should you troll with or against the current?
When in an area with current, troll crosscurrent as opposed to with and/or against the current. Going crosscurrent, you don’t have to worry about how the current is affecting your lure’s or bait’s speed through the water. Plus, fish generally swim into the current.
How long should a trolling rod be?
Fishing rod size chart
| Fishing rod type | Length range | Most commonly used length |
|---|---|---|
| Surf casting rod | 9′ to 14′ | 10′ to 12′ |
| Boat rod | 5′ to 7′ | 6′ to 6’6″ |
| Trolling rod | 8′ to 14′ | 9′ to 11′ |
| Ice fishing rod | 20″ to 48″ | 28″ to 36″ |
How fast do you troll for marlin?
One of the best methods to locate marlin early in the season is by trolling a set of marlin lures. Most boats troll at 6.5 to 8 knots and stagger trolling lures along the ‘clean’ lanes or alleys which form behind a boat at trolling speed. Placing your trolling lure in these lanes is critical.
How far offshore do you need to catch tuna?
You don’t have to travel very far to catch them – your fishing charter will take you about 50 miles offshore you will find schools of them swimming there, but if you want an even bigger catch you can travel about 75 miles offshore because this is where the real winners are to be found.
What is the best trolling speed for stripers?
According to the Fishaholics, when fish are less active, the ideal speed is about 2.0 to 2.5 mph. When the fish does not bite, or the bite is tough, it is better to go below to 2.0 mph. However, if striped basses are active, you can opt for a higher speed between 2.5 and 3.5 mph.
Can fish see braided line?
Braided lines, despite the fact they are thin, are more visible to fish. Monofilament ones are a bit less visible than braided ones. Secondly, if the color is wrong, fish will see the line even better. Many fish species are very cautious and a simple thing like a visible line will easily turn them away.
Can you troll with fluorocarbon?
The good news is fluorocarbon has lots of properties that make it a great trolling line. The real advantage of fluorocarbon line isn’t the ability to get things deeper, but the nearly invisible nature of fluorocarbon line in water.
Contents