According to the Fishaholics, when fish are less active, the ideal speed is about 2.0 to 2.5 mph. When the fish does not bite, or the bite is tough, it is better to go below to 2.0 mph. However, if striped basses are active, you can opt for a higher speed between 2.5 and 3.5 mph.
What should I use to troll for striped bass?
While stripers will be hugging the bottom most often, at times, a bait swimming through the middle of the water column will get more bites. Different plugs will have different actions, so carry an array of deep divers including the Rapala X-Rap Magnum, Sebile Koolie Minnow, Mann’s Stretch, and Bomber CD.
How deep do you troll for striped bass?
Light: Also sunrise and sunset hours are ideal for stripers. Also, as importantly, boat traffic is at a minimum during these times. Depth: Your focus is on bottom dwelling fish. Have gear for the depths you’ll be fishing, say 10′ to 50′.
Should you troll with or against the current?
When in an area with current, troll crosscurrent as opposed to with and/or against the current. Going crosscurrent, you don’t have to worry about how the current is affecting your lure’s or bait’s speed through the water. Plus, fish generally swim into the current.
How far up the Hudson Do striped bass go?
There is a slot limit for stripers on the river now. Anything 28 inches or more has to released. In the tidal Hudson River north of the George Washington Bridge, the recreational slot limit is one fish no less than 18 inches nor greater than 28 inches, and the season is open April 1 through Nov. 30.
How far behind the boat should I troll?
Every boat is different and you should make your boat your own study. Proper distance for most boats will be anywhere from 20 feet to 150 feet behind your boat. Whether you have inboard diesel or outboard gas engines, your power dictates the distance you troll your baits and lures.
What is the best bait for freshwater striped bass?
Bunker and Herring as Striped Bass Baits
Bunker (also known pogies or alewives or, properly as menhaden) are probably the number-one most common bait used for stripers, and herring aren’t far behind. We’re lumping these two types of fish together because they’re extremely similar and usually are equally effective.
How much line should I put out for a troll?
Trolling Depth Trick #3
Consider the following example: If you’re trolling a tandem rig tied with two five-ounce bucktails (5 x 2 = 10), and you let out 100 feet of line (double 50, so multiply by two again), according to the Rule it will run at about 20 feet below the surface (5 x 2 = 10 x 2 = 20).
How do you slow troll?
Drift socks and trolling bags can also slow your trolling speed. Like parachutes, these devices increase drag, and that’s what reduces speed. Trolling bags offer more robust construction than do drift socks to withstand the additional pressure on the chute and straps from a moving boat, especially in rough seas.
Are there sharks in the Hudson River?
In July, a shark is reported in the Hudson River off 42nd Street. Police as far north as Poughkeepsie are warned.
Are stripers running in the Hudson River?
Most stripers originate in the rivers that drain into the Chesapeake Bay region, but the Hudson River Estuary forms the second largest spawning grounds for these fish, with the Delaware River contributing to the stock as well.
What speed do you troll at?
So, what is the best trolling speed? The best trolling speed depends on several factors including the type of fish, water conditions and lure choice. In general, trolling speeds between 1.5 and 2.5 mph, as measured by GPS, are a good starting place for most species like walleye, trout and salmon.
How fast do you troll an umbrella rig?
At typical trolling speeds of two to four knots, you can figure on one foot of depth for every ten feet of wire in the water. For example, letting out 200 feet of wire will put the rig at 20 feet. It’s a simple and accurate way of presenting umbrellas to deep-holding fish.
What temperature water do striped bass like?
around 55- to 68-degrees
Stripers prefer water temperature around 55- to 68-degrees. If the water is too hot, they may feed shallow occasionally, but quickly return to the oxygenated rich, cooler water. Same goes for extremely cold water.
What is the best time to go striper fishing?
The best time of day to catch striped bass is early morning from dawn until about 2 hours after sunrise and late afternoon from 2 hours before sunset until dusk. Fishing for striped bass can be even better in the hours before a major cold front or rain event arrives.
How do you bounce the bottom of a striped bass?
Keep the sinker in contact with the bottom at all times. the rod stays in your hands. pick the rod up till the sinker comes off the bottom and slowly let it back down till it touches. Keep repeating this until you are hooked up.
What is biting in the Chesapeake Bay?
Our primary targets are Cobia, Red Drum, Spanish Mackerel, and an assortment of bottom fish. This is by far some of the best fishing of the year as we chase the Cobia and Red Drum that average between 30 and 60lbs.
How do you fish for stripers in the Chesapeake Bay?
Fishermen throw lures by the islands and jig around pilings of the CBBT. Other popular and effective techniques include trolling large deep diving plugs like Mann’s stretch 25s in the waters around the mouth of the Bay and todrift live eels under bobbers over and near shoals.
Where are they catching rockfish in the Chesapeake Bay?
The Upper Chesapeake Bay
- Susquehanna Flats: As this mighty river flows to sea, the flats are a great spot for targeting Rockfish.
- Rocky Point Beach: With waters averaging between 3–12 feet, everything’s possible around this beautiful fishing spot.
Contents