What Button Do I Press To Get A Meter Reading?

To read the meter:

1. press the middle button.
2. write down the number below ‘IMP’ from left to right.
3. ignore any zeroes at the beginning and any numbers after the decimal point.

How do I read my electric meter?

When reading an electric meter, read and write down the numbers as shown on the dials from right to left. When the pointer is directly on a number, look at the dial to the right. If it has passed zero, use the next higher number. If it has not passed zero, use the lower number.

Where is the meter number on a electric meter?

Meter Numbers
Your meter number is usually stamped or printed at the bottom of the face plate in BOLD BLACK numerals and can be up to ten digits in length.

What are the A and B buttons on my smart meter?

This is your electricity reading. If your meter has an ‘A’ and ‘B’ button, press ‘A’ until you get to TOTAL ACT IMPORT. The number below this is your electricity reading. Your meter might have three buttons to the side of the display.

How do you read electric A and B buttons?

If your meter has A and B buttons under the screen
press the A button again until you see ‘METER INDEX’ and numbers followed by ‘M3’ write down the number from left to right. ignore any zeroes at the beginning and any numbers after the decimal point.

How do you read a smart meter with A and B button Eon?

If you have A and B buttons

1. Press either the red ‘A’ or black ‘B’ buttons to wake up the display.
2. Your reading should now be visible on screen. It may display “METER INDEX”
3. Ignore any digits after a decimal point if you have one. We only require the whole numbers.
4. In this example the meter reading is 135.

Why is my smart meter not connecting?

SMETS1 smart meter
Take your In-Home Display to where your electricity meter is located. Once you’re close to the meter, hold down the “OK button” until the In-Home Display turns off and then on again. You should then see the message: “your smart meter is now paired”.

What do I do if my smart meter is not working?

The smart meters are probably still working well. The IHD needs a good charge on its battery, or to be plugged in, also it needs to be quite close to the actual electricity meter. To reset it it turn it right off by holding down the power button for 10 seconds and then power it back on again, it should work.

How do I reconnect my electric smart meter?

Reconnecting your electricity meter

1. Press A and B at the same time – hold for about 10 seconds.
2. You should hear a click when you’re back on supply.

How do I turn on my gas smart meter?

To re-enable your gas supply:
Press the middle button on your gas meter. Press and hold the middle button. The gas meter will attempt to open the valve. Once the gas appliance check has been completed by the meter, it will display ‘Gas Flow Check Successful’.

How do smart meters communicate?

How do smart meters communicate? Smart meters don’t need the internet to communicate. Instead, they work by using two wireless networks: the HAN (home area network) and WAN (wide area network). Your HAN is a secure network contained within your home that allows digital devices to communicate with each other.