SCAFFOLDING INSPECTION CHECKLIST Ensure that the platform is 14 inches or less away from the wall or 18 inches or less away if plastering/stuccoing. Make sure there are guardrails, including mid rails and toe boards on platforms where work is being done.
How far from wall should scaffolding be?
The 14 inch rule in 1926.451(b)(3) applies in all circumstances where there is no guardrail or personal fall arrest system, except as noted in 1926.451(b)(3)(ii) which extends the distance to 18 inches for plastering and lathing.
What is the maximum recommended gap between scaffold and structure?
The gap between a working platform and the face of the structure must be as small as possible, except in the case where it is necessary for a person to sit on the edge of the platform to work, when the gap should not exceed 300 millimetres.
What is the maximum distance the edge of the scaffolding can be from the work surface?
14 inches
Except as provided in paragraphs (b)(3)(i) and (ii) of this section, the front edge of all platforms shall not be more than 14 inches (36 cm) from the face of the work, unless guardrail systems are erected along the front edge and/or personal fall arrest systems are used in accordance with paragraph (g) of this section
What is the distance of scaffolding?
Single Scaffolding:
Single scaffolding consists of only one row of standards spaced at a distance of about 1.2 m from the wall and in between them is about 2.0 – 2.4 m. The vertical spacing of ledgers is about 1.2 – 1.5 m and spacing of putlogs is 1.2 – 1.5 m. Boardings and guards are also provided.
Where scaffold platforms are more that 24 inches above or below a point of access a means of access shall be provided?
In regards to the first part of your question, when a work platform is more than 24 inches below its point of access, you must provide a means of access to it such as a portable ladder, hook on ladder, or attachable ladder.
Why are guardrails needed at the leading edge of a scaffold?
The standard’s definition of a guardrail system is: “a vertical barrier, consisting of, but not limited to, Toprails, midrails, and posts, erected to prevent employees from falling off a scaffold platform or walkway to lower levels [emphasis added].” Therefore, guardrail systems must have midrails.
Do you need permission to put up scaffolding?
If your builder or scaffolder needs to put up scaffolding within the boundary of your property there is no need for a licence. However, if any part of the scaffolding needs to go on the pavement or the road outside your property your builder or scaffolder must get a licence from your local council.
How many boards wide can a scaffold be?
Board Brackets
Such brackets may be used within TG 20 compliant independent scaffolding provided that the inner platform at a maximum of one lift is so extended per elevation of scaffolding. The remaining inside platforms should be up to two boards wide unless design advice is obtained.
Is scaffolding attached to a building?
If a scaffold is tall enough, it will need to be anchored to something, such as the side of a building. The height of the scaffold will be compared with other factors to determine its stability.
Do scaffold planks need to be secured?
It merely noted that, “all planks shall be secured from movement or overlapped in accordance with §1926.451(a)(12).” Like the current standard, the 1975 standard did not address this issue (section 1926.451(a)(12), stated simply that “all planking of platforms shall be overlapped (minimum 12 inches), or secured from
Can a person ride on a rolling scaffold?
(i) Riding. Employees may ride on rolling scaffolds moved by others below if the following conditions exist: (1) The floor or surface is within 3 degrees of level, and free from pits, holes, or obstructions; (2) The minimum dimension of the scaffold base, when ready for rolling, is at least 1/2 of the height.
Do scaffolders have to wear a harness?
Industry guidance requires scaffolders to wear and use a fall arrest harness when more than 4m above ground without a safe platform to stand on and edge protection in place.
How do you calculate scaffolding?
Divide the total height measurement by the height of a single scaffolding section. This will determine the total number of rows of scaffolding the project will require. Multiply the number of rows by the number of columns to find the total number of scaffold sections necessary for the project.
What are the 3 types of scaffolds?
Yet, despite the many types of scaffolding, there are only three main categories: suspended, support, and aerial.
How long can a scaffolding stay up?
There are no regulations on how long scaffolding can be left up due to different projects taking different lengths of time to complete.
Can a ladder be used on scaffold?
As you can see from §1926.451(e)(2)(iii), when attachable ladders are used on supported scaffolds more than 35 feet high, they must have rest platforms at no more than 35-foot intervals. There is no requirement in the standard that workers use fall protection while climbing up or down these ladders.
At what height must a scaffold be supported to help prevent tipping?
10 feet
The standard requires employers to protect each employee on a scaffold more than 10 feet (3.1 m) above a lower level from falling to that lower level.
What is the maximum height of a rolling scaffold?
by 6.167 ft.; the 6-foot scaffold becomes 6 ft. by 6.417 ft.; the 7-foot scaffold becomes 7 ft. by 7.333 ft.
OSHA.
Model (not using outriggers) | Total height* at which restraint is required |
---|---|
4-foot (26 inches wide) | over 8.668 feet |
6-foot (29 inches wide) | over 9.668 feet |
What distance from any edge do you require fall protection?
State OSHA guidelines may vary, but in NO CASE is mere distance from an edge considered sufficient protection when a fall hazard of over 6 feet to a lower level exists. So, when working at height, workers must have some protection from falls from a leading (unprotected) edge. OSHA is clear on this point.
How far from the edge must warning lines be installed?
15 feet
A warning line is used 15 feet or more from the edge (or nearest edge of a hole); The warning line meets or exceeds the requirements in §1926.502(f)(2); No work or work-related activity is to take place in the area between the warning line and the hole or edge; and.
Contents