What is the purpose of a rod sleeve?
Rod sleeves, or rod jackets, help protect your rods and decrease the chances that they get stuck on something.
What is the purpose of rod socks?
Rod socks are tightly woven expandable mesh sheaths, designed to house fishing rods. Capable of protecting the length of the rod, including fragile guides and tips, they will also save fishing line from tangles and abrasions when lures are tied on.
What is a spinning rod sleeve?
Made from a tightly woven mesh material, the Tackle Warehouse Spinning Rod Sleeves easily cover rods to protect them from damage and eliminate tangling issues in your rod locker or garage.
How are rod socks measured?
Use a tape measure or strip of paper to measure the circumference around your rod blank and line guide. Measure your circumference with a strip of paper. Compare your measurement to the circumference illustration and select the cover for your rod. Now all you need is the length.
What are fishing rod covers made of?
polyethylene filament
Fishing rod covers made of a tough polyethylene filament that is virtually impervious to salt.
What length rod should I get?
A short (6 feet or less) rod is ideal if you want to make short, accurate casts. When pinpoint accuracy is less critical, a long rod (over 7 feet) is the way to go. Dingy or dirty water and heavy cover are two situations where short-range accuracy is part of the recipe for success, and a shorter rod can really shine.
What size is a standard fishing rod?
6-12 feet
The length of a fishing rod typically ranges from 6-12 feet, so to choose a measurement for your needs, consider the type of fishing you plan to do, the species you are after and your fishing environment. A good length for beginner anglers is usually around 7 feet.
Can you cut down a rod blank?
As a rule of thumb, you can cut up to 6 inches off the butt of any 1-piece Rodgeeks blank without affecting the action of the blank. Say you like the action and power of our new 8-foot X-Comps, but want the rod to only be 7 feet 6 inches.As a rule of thumb, avoid cutting the tip of any carbon fiber blank.
How do you cut a carbon fishing pole?
Move the razor blade forward and backward, rolling the carbon fiber rod forward and backwards against the tabletop while maintaining gentle downward pressure. The blade will cut through the individual strands of carbon one at a time. Rolling the rod over the wet paper towel will cause the rod to be continually damp.
How do you cut a blank Ice rod?
No matter how much you take off just remember you will change the action of the rod. To cut the butt end of an ice blank I’ve taken a sharp utility knife and rolled it over the blank back and forth cutting a deep grove into it and you can then just snap it off. Then just clean up the end with a medium little sandpaper.
Contents