If you want to factory default your Yale Z-Wave Lock, complete the following steps:
- Prepare the lock. Remove the battery cover from the lock.
- Press the reset button. Press the reset button, and keep it held down.
- Reapply power. With the reset button held down, reinsert the battery to reapply power.
- Reassemble the lock.
How do I reset my Yale door lock code without master code?
I’ve forgotten or need to change my Primary Code
- Locate the black battery cover at the top of the inside door handle.
- Remove the battery cover.
- Then remove the rear cover.
- Now remove the cable.
- Press both the I and P buttons at the same time and then place the batteries back in.
Why is my Yale lock not working?
If you find that the issue is the lock, try rebooting the lock first. To reboot the lock, remove one battery from the lock and replace it. Once you have rebooted the lock, try the entry code again. If this does not work, the keypad must be reset.
How do you pair a Yale lock?
In the Yale Access App, go to the side menu (upper left), tap Set Up New Device. Choose Set Up Yale Connect Bridge. Choose a lock with which to associate your Connect. When prompted, plug connect into an outlet near your door and then follow the in-app instructions.
How do I reset my digital lock?
Take these steps to reset your lock:
- Pull up the shackle to open the lock.
- Rotate the shackle 90° counterclockwise and press all the way down.
- Hold down the shackle and set your own combination by turning dials.
- Turn the shackle back as normal. The setting is now complete.
Why is my Yale lock not locking?
Try these quick fixes: Gently close your door and use the thumb turn inside your home to lock it. If there’s any friction, or if you need to push or pull on the door to get the lock to fully engage, it’s a good sign your deadbolt is misaligned. With the door open, extend the deadbolt and clean it thoroughly.
How do I get my Yale lock back online?
Your lock doesn’t connect directly to Wi-Fi. Instead, it uses a Google Nest Connect or Google Nest Guard for its internet connection. So you’ll only need to update the Wi-Fi information on your Connect or Guard in order to get your lock back online.
Is Z-Wave a ring?
Ring Uses Z-Wave.All Ring devices are Z-Wave compatible. Ring Alarm’s base station operates as a Z-Wave hub, so the elements of the Ring Alarm system can communicate with each other without interfering with your home’s Wi-Fi network.
How do I reset my Ring Alarm base station?
To factory reset your Keypad, press and hold the pinhole reset button in the back of the Keypad for 10 seconds, until it flashes red.
Range Extender (1st gen)
- Plug in the Range Extender.
- Press and hold the button on the right hand side of the device.
- When the LED begins to blink slowly, release the button.
Where is the QR code on Yale lock?
When setting up your product, the app will ask you to first scan your Yale Access QR Code. This code is located on either documentation insider your packaging, on your smart module, or on the battery cover of your product. If you cannot locate your QR code, you can manually enter the serial number into the app.
How do I reset my nest Yale lock?
Remove the mounting plate to reveal the reset button, which is located on the left side of the cable connector. Hold down the reset button while you put in the batteries. Keep holding down on the reset button until the light turns red and the lock says Just a moment, erasing all settings. Release the reset button.
Contents