1 Factory Reset a Spotlight/Floodlight Cam
- Make sure the camera is powered up.
- Press and hold the reset button atop the camera for 30 seconds.
- After releasing it, the status light located at the bottom will flash a few times indicating the camera is restarting.
- The camera is now reset to factory defaults.
Why is my ring floodlight camera not working?
Check that all of your wires are properly plugged in and that all the lights on the front of the router are green. Check to see whether another Wi-Fi device is having a problem connecting to the network. Unplug your router for 30 seconds and then plug it back in. See if your Floodlight Cam automatically reconnects.
How do I reboot my ring camera?
Ring Spotlight Cam Battery
- Find the setup button on the top of the camera.
- Press and hold the setup button for 10 seconds.
- The light on the front of the camera will flash for several minutes; when the light turns off the reset is complete.
How do I reconnect my flood light ring?
How to Reconnect Your Ring Doorbell or Security Camera to Wifi or Change Your Wifi Network
- Tap on the three lines on the top left.
- Tap Devices.
- Select doorbell or security camera you need to reconnect to wifi. The next screen is the Device Dashboard.
- Tap on Device Health.
- Tap on Reconnect to Wifi or Change Wifi Network.
To reset the Ring 2, hold down the black button on the front of the doorbell for 20 seconds. To reset the Ring Pro, hold down the black button on the right side of the camera for 20 seconds.
Why is my ring not lighting up?
There are two possible reasons why your light isn’t lighting up: You’re keeping the right button pressed too long. Ensure that you are pressing the button firmly and releasing it immediately without holding it down. Your Video Doorbell Pro isn’t receiving power.
How do I reconnect my outdoor camera Ring?
Press the Setup button on the Ring device to put the device in Setup mode. Wait 10 seconds, then press it again and see if your Ring automatically reconnects.
How do you reset a ring light?
Resetting your Ring Smart Lightbulb
- Using a power switch, turn the bulb off.
- Turn the bulb on and off six times. Each on cycle should last two seconds and each off cycle should last two seconds – for a total of four seconds.
- Wait about 30 seconds.
- At this point, your Ring should now be back to factory settings.
How do you reset a ring chime?
Insert a pin or paperclip into the pinhole, then press and hold the reset button for 15 seconds. Release the reset button. The status light located on the front of the Chime will flash quickly a few times indicating that it is restarting. The chime is now reset to factory defaults.
How do I reset my ring to factory settings?
Remove the doorbell’s faceplate then press and hold the reset button on the right side of the camera for 15 seconds. After releasing it, the ring light located on the front will flash a few times indicating the doorbell is restarting. The doorbell is now reset to factory defaults.
What causes flood lights to stop working?
Corroded electrical lamp socket base or sides: if your outdoor light or floodlight is flickering or goes out entirely the cause may be the obvious ( a burnt-out bulb) but it might be more subtle: corrosion in the bulb socket.
How do I reset my outside security light?
Turn the light switch on and off rapidly approximately four times. The light will eventually stay on continuously. Once the light is on, turn the switch off, wait five seconds and turn it back on again. The light should stay off and the sensor should be reset.
What do you do when your ring chime is not working?
You can try unplugging the Chime Pro and plugging it into another nearby outlet. You can also hold down the reset button on the side of the Chime Pro for 10 seconds and release it to power cycle the Chime Pro.
Contents