For all our Z-wave plus in-wall switches you will click the upper switch 3 times rapidly, and the lower switch 3 times rapidly. On our paddle switches the blue LED will flash 5 times to confirm the reset (there is no LED on the toggle switches to confirm the reset).
How do I reset my Z-Wave?
1) Press and hold the Aeotec Z-Wave device for 20 seconds, then release to perform a Hard Reset.
How do I reset my Z-wave SmartThings?
- Open SmartThings app.
- Tap Menu located at the top left corner of your screen.
- Tap Devices.
- Find your hub and select it.
- From the upper right 3 dot menu, tap Z-Wave Utilities.
- Tap Z-Wave Exclusion.
- Ensure that the LED on Smart Home Hub is blinking.
- Tap the button on the Z-Wave device that you want to factory reset.
What is Z-wave exclusion mode?
Remove Devices
Removing Devices is known as the Exclusion Process. It will not only remove a device from your Z-Wave hub but also factory reset the device. It doesn’t matter if the device has never been paired with your hub, exclusion mode will always give you a response no matter how many times you remove a device.
How do I reset my GE Z-wave outlet?
To remove and reset the device Once the controller is ready to remove your device, press and release the button on the smart outlet to remove it from the network. To return to factory defaults Press the button 3 times, then press and hold the button for at least 3 seconds. The LED will blink 5 times to confirm.
What is a Jasco fluorescent light and appliance module?
Transform any home into a smart home with the Jasco Z-Wave Wireless Lighting Control Fluorescent Light and Appliance Module.It provides a Z-Wave enabled outlet for the lamp or appliance that you would like to control and a regular pass-through AC outlet for other electrical appliances.
How do you reset a GE toggle switch?
Reset to factory default
Quickly press ON (up) 3 times then immediately press the OFF (Down) button 3 times. Note: This should only be used in the event your networks primary controller is missing or otherwise inoperable.
How do I reset my Honeywell Z-wave light switch?
Reset to factory default
Quickly press ON (Top) button three (3) times then immediatelypress the OFF (Bottom) button three (3) times. The LED will flashON/OFF 5 times when completed successfully.
Can a Zwave device be connected to two Z-wave hubs?
As per Z-Wave specification, no. A Z-Wave node (device) can only be paired to one hub (the designated ‘primary’ controller). ‘Secondary’ controllers added to the primary controller will lose their z-wave netword/added nodes and just act as a relay remote control.
Is Zwave going away?
The short answer is no, the standard is far from dead and still receives a lot of updates from its creators. Many different standards can exist at the same time without putting one another entirely out of the game.
What is Z-Wave inclusion mode?
Inclusion mode broadcasts a message from the Wink Hub to nearby Z-Wave devices saying it’s ready to connect a new product. This is essentially the same command that is sent when you reach the final step of the Add a Product instructions.
How do you start over with Smartthings?
Factory reset SmartThings Wifi hub
Tap Network status, and then tap your Wi-Fi hub. Tap More options (the three vertical dots), and then tap Factory reset. Tap Reset to confirm.
Contents