When the lights match a blinking blue and solid green pattern, then press Discover Device and you are asked to join the Sync Module Wi-Fi network. Tap Join, and then select your Wi-Fi network from the available choices. Carefully enter your Wi-Fi password and tap Join on your keyboard.
How do I get my blink camera back online?
If your camera is in this state, you may need to try the following troubleshooting steps to get that camera back online. Power cycle your camera by removing the batteries for 5 seconds and reinserting them. Wait 30 seconds, then try using that camera again. Move the camera closer to your Sync Module.
Why is my blink camera not connecting to the Internet?
Restart your device, or try switching the Wi-Fi setting off and on again to establish a connection. Make sure your mobile device is within range of your router or access point. Check that your router and any access points are powered on. Restarting your Wi-Fi router may also resolve this issue.
The reset button is located on the right-hand side of the Sync Module next to the USB port. Please note that this could take between 15-30 seconds. This will cause the Sync Module to reboot into setup mode.
How do I reconnect my camera after changing the battery?
Power cycle both your modem and your router by unplugging them for 30 seconds and plugging them back in. Wait two minutes for Internet service to be restored, then try using your camera again. Power cycle your camera. To do this, remove the batteries for 10 seconds and reinsert them.
How do I restart my blink camera?
To reset a Blink camera, reset the Sync Module by holding down the button on the module’s side until its light turns red; this resets the Blink camera system and requires reinstalling the module in the Blink app to use the camera again.
How do I reconnect my Blink Sync module?
If you are having any issues with your Sync Module, it is best to first power cycle the Sync Module by unplugging the power cord from the back of the unit for 10 seconds and then plug it back in. This should cause the device to reboot and then reconnect within 45 seconds displaying a solid blue and solid green light.
Does blink camera connect to WIFI or sync module?
Blink’s original Indoor, XT, and XT2 cameras will only connect to the same Wi-Fi SSID that the Sync Module is connected to. To set up these cameras with an extender, be sure to rename the Wi-Fi extender SSID to be the same the main Wi-Fi network, and use the same password.
What does connection reset mean on Blink camera?
This reset will allow you to reconfigure your device settings and prompt you to put in new Wi-Fi credentials.The system will only update itself when the Wi-Fi connection is steady, and the power supply is stable.
How do I reset my Blink camera without syncing the module?
Blink mini camera doesn’t need sync module to operate. Therefore, Blink mini cameras have to be reset separately through the reset button available on the bottom of the camera. Press and hold the reset button for 10-15 seconds.
The Blink Mini has a reset button on the bottom side of the camera, which may be necessary to use when you add it to a new or existing Blink system. In a case when you move the Mini to a new location or Wi-Fi network, you may also need to use the reset button.
What is the USB port on Blink Sync module for?
The Sync Module has a USB port as well, we intend to release a firmware update for it that will allow video clips to be stored locally in the sync module rather than in the cloud.The camera has a micro-USB port for power in case you don’t want to run the camera with batteries.
Contents