How Do I Get My Shower Curtain To Stay In Place?

No matter what causes your shower curtain to fly in at you, there are a couple of remedies to keep it where it needs to be.

1. Buy a weighted curtain.
2. Upgrade your curtain liner.
3. Install a curved shower curtain rod.
4. Grab a suction cup and binder clip.
5. Try magnets.

Why does my shower curtain keep moving?

When the hot air rises the air supply in the lower half of the shower becomes ‘depleted’ and new air wants to enter through the bottom of the shower area. When air isn’t able to get in, the shower curtain and liner start pushing inward towards you.

How do I stop my shower tension rod from falling down?

Hang the shower curtain rod at an angle, with one end several inches higher than you want it. Slowly slide that end down until the rod is hanging straight. What is this? The felt pads keep it from sliding further down the tile wall.

What are the magnets on shower curtains for?

The Shower Curtain Magnets allow you to easily and quickly close your shower curtain. Installation is easy: The wall/Tile side magnets used strong non permanent outdoor tape – The Curtain side Magnets use a nickel coat pin with a nickel coated locking back.

What can I use for drapery weights?

Two main types of drapery weights exist: penny weights and chain weights. Penny weights actually look like buttons thanks to the four holes in the middle. This allows you to sew the weights securely to the hem of the curtain.

How do you put weights on a shower curtain?

Drapery Weights
After folding up and stitching a hem across the bottom of the shower curtain, slide one weight into each open end of the hem and stitch the ends closed. If the curtain is too short for a hem, you can sew the fabric or mesh drapery weight pouch to the back bottom edge of the curtain.

Do shower curtains go inside or outside of the tub?

Ideally, the curtain should be hanging inside the tub, keeping the water from getting out of your shower area. Hence, if you’re not using your bathroom, you can put it outside to hang. Indeed, shower curtains have a significant role in protecting the tiles outside your shower area.

Do tension shower curtain rods work?

If you’re not comfortable installing a mounted rod, a tension rod is a good idea. Both are strong enough to hold most shower curtains.

How do you attach a magnet to a shower curtain?

Line up your shower curtain to the first magnet and mark the curtain there. I recommended placing the second magnet on the inside of your curtain as the curl inward will keep more water inside, where it can keep you clean, rather than outside, where it can make you fall on the ground and then bam!

How do you put in drapery weights?

Position a covered drapery weight into one lower corner of the hem, approximately 1/2 inch from the bottom fold and 1/2 inch from the side edge. The front and back of the covered weight will be invisible from the outside. Thread a hand-sewing needle with thread color-matched to the curtain color, and knot one end.

Should you leave the shower curtain open or closed?

A shower curtain should be closed when not in use. Once you leave it open, mold and mildew can develop inside the folds.This is because an open shower curtain folds on itself which makes causes the water to get trapped between the plastic and makes it hard to dry. This can eventually cause mold to grow.

How far should a shower curtain hang into the tub?

Standard shower curtains are 72 inches long by 72 inches wide. If your shower has a tub, it’s recommended that the shower curtain and liner, if you’re using one, hang below the lip of the tub at least 6 inches.

Can you use shower curtain without liner?

While it’s certainly possible for fabric shower curtains to go without a liner, it is not recommended. Since fabric curtains can retain a lot more water, you’ll want to add a liner to protect it and provide additional privacy.

Do you hang shower curtain and liner on same hooks?

“And always use double hooks so that the liner can hang inside the tub while the decorative curtain stays on the outside,” Pulcine suggests.“This way, the liner sticks to the porcelain and doesn’t attack you in the shower,” she reports.

How does a curved tension shower rod work?

A curved shower rod pushes the shower curtain away from the shower stall, creating more room in the shower for moving around. This isconvenient for handicapped people who may require additional room to get in and out of the shower and maneuver around the shower stall itself.