3 feet.
Bathroom Outlets Every bathroom must have at least one electrical outlet. It must be a GFCI, and it must be within 3 feet of the edge of the sink. Either behind or beside the sink is acceptable — across from the sink on an opposite wall is not.
How close can an electrical outlet be to a bathroom sink?
Outlet Receptacles
You should keep the receptacle at least 6 feet away from the edge of a bathtub or shower and at least 1 foot away from sinks.
How close to a sink can you have a socket?
30cm horizontally
Electrical sockets or switches should be fitted at a safe distance (it is recommended at least 30cm horizontally) from a sink to avoid the chance of water coming into contact with electricity. Sockets should also be easily accessible.
How far does a GFCI have to be from a sink?
6 ft.
Generally, all 15 or 20-amp, single phase, 125-volt receptacles within 6 ft. of a sink, tub or shower must be GFCI protected. For a sink, the measurement starts from the top inside edge of the bowl of the sink. For a bathtub or shower, the measurement starts at the outside edge of the bathtub or shower stall.
What is the maximum distance an outlet can be from a vanity?
In kitchens, electrical outlets should be placed no farther than 48 inches apart, so that no point on the countertop is more than 24 inches away from a receptacle. Any countertop 12 inches wide or more should have an outlet on the wall behind the countertop.
Can you put an electrical outlet under a sink?
Typically there are outlets (receptacles) under the sink. The dishwasher as well as the disposal is plugged into an outlet with an appliance cord. The vast majority of the homes I inspect have one or more outlets deliberately installed there just for those reasons.
Does outlet under sink need to be GFCI?
2 Answers. There are no requirements in National Electrical Code (NEC) that a residential disposal must be GFCI protected. However, there may be requirements in the installation instructions, which would make GFCI protection required. 210.8(A) requires receptacles serving the kitchen countertop to be GFCI protected.
What is the minimum distance between electrical outlets?
The US National Electrical Code, Section 210.52, states that there should be an electrical outlet in every kitchen, bedroom, living room, family room, and any other room that has dedicated living space. They must be positioned at least every twelve feet measured along the floor line.
How close can an electrical outlet be to a water source?
6 feet
According to the National Electric Code, any receptacle within 6 feet of a water source needs to be protected with a GFCI.
Can you put an outlet above a sink?
The National Electrical Code doesn’t have any specific requirement regarding the height of a receptacle above a vanity. The only thing the NEC requires is that there must be one outlet within 36 inches of the outside edge of the sink, and it must be in the wall adjacent to the basin or countertop.
What is the maximum distance between outlets?
12 feet
Since the maximum distance to a receptacle is 6 feet (1.8 meters), the maximum distance between two receptacles is doubled. Therefore, the maximum distance between receptacles is 12 feet (3.6 meters).
Can you put an outlet under a bathroom sink?
Because bathrooms are wet, they come with their own specific electrical requirements, including but not limited to the following. All outlets must be GFCIs (ground-fault circuit interrupters), to protect from electrocution.There must be an outlet placed within 36 inches of the edge of the sink.
Is under a sink considered a wet location?
A wet location is an interior location that is subject to saturation with water or an exterior location subject to saturation with water or unprotected and exposed to the weather.Sinks have a proximity damp zone of a 2 feet radius in all directions from the water source.
Can you run Romex under sink?
Type NM cable is only required to be protected “where subject to physical damage“. This is entirely a judgement call, but IMO, it is not. You should secure the cable to the surface as required.
How many outlets can you run off a GFCI?
There’s no limit. A standard GFCI will protect up to 20 amps, drawn from any combination of receptacles, either the built-in one or any number of additional ones connected to its load terminals.
Should a dishwasher be plugged into a GFCI?
The 2014 NEC has a new requirement for ground-fault circuit interrupter (GFCI) protection of dishwashers in dwelling units.The new requirement is for GFCI protection of outlets that supply dishwashers installed in dwelling-unit locations.
Is there a difference between GFI and GFCI?
GFCI vs GFI. Ground fault circuit interrupters (GFCI) and ground fault interrupters (GFI) are the exact same device under slightly different names. Though GFCI is more commonly used than GFI, the terms are interchangeable.
What is the minimum wall space that must have a receptacle installed?
A receptacle outlet must be installed in every kitchen, family room, dining room, living room, sunroom, parlor, library, den, bedroom, recreation room, and similar room or area so that no point along the wall space is more than 6 feet, measured horizontally along the floor line, from a receptacle outlet [210.52(A)] (
How many outlets can be on a wall?
A standard 20 Amp breaker can handle up to 10 electrical outlets, experts say. With a maximum suggested load of 80%, up to 10 devices can be connected at the same time, depending on their electricity usage. If their total electricity usage exceeds 1,920 watts, you’re risking overloading the circuit.
Are outlets allowed in baseboards?
But there is a better way. By installing electrical outlets in the baseboard molding of your home they can seamlessly integrate into a design element that almost camouflages the outlet. By doing this small detail, you can eliminate the presence of noticeable unsightly cords and wires from your home.
How high should an outlet be over a bathroom vanity?
A typical bathroom counter is 32 to 36 inches above the floor. A bathroom counter usually has a 4-inch backsplash, where the counter surface turns up the wall. Backsplashes prevent water from running behind a countertop. An electrical outlet receptacle is usually placed 2 to 3 inches above the top of the backsplash.
Contents