You can reconnect the hub to your Wi-Fi by going to your Hive app, tap the Hub 360, Settings, Change Wi-Fi, and follow the in-app instructions. Step 6. Go back to ‘Menu’ in the Hive app, tap ‘Manage devices’ then refresh the page. If the hub is showing as ‘connected’ you’re done!
How do I reconnect my Hive to a new WIFI?
Log into the Hive app and tap your Hive Leak Sensor. When viewing the product page, tap the settings icon on the top right and then tap ‘Change Wi-Fi’. You will be guided through steps to connect to your new network.
Why has my Hive gone offline?
If your Hive Light is showing as offline in your Hive app or website dashboard it could be because it’s been switched off manually from the existing light switch on the wall or lamp.If your wall or lamp light switch is switched to on and you’re still unable to control Hive Light remotely, try restarting your Hive Hub.
Why is my Hive hub not connecting?
Unplug Hub 360 from the wall socket and reinsert it, wait for the hub to reboot (this can take about 10 minutes) then refresh the Hive app dashboard page in the app. Step 4.You can reconnect the hub to your Wi-Fi by going to your Hive app, tap the Hub 360, Settings, Change Wi-Fi, and follow the in app instructions.
Does Hive need to be connected to router?
Our newest hub, Hive Hub 360 connects via Wi-Fi, our other hubs need to be physically connected to your broadband router using a network cable (provided with the hub) to allow you to control your Hive products remotely.
How long does it take for Hive to reconnect?
This usually takes 5-10 minutes. Once the AMBER light is flashing, the hub is set up and you can move onto installing the receiver. If no lights are displayed immediately after the hub has been turned on, check all cables are connected and the power socket works.
How do I restart my Hive?
The Hive Hub can be reset by pulling the power cable out and putting it back in again. It will take about 5 minutes to fully reboot and pair to your devices. After the 5 minutes, refresh the app or website.
How do I reset my Hive hub?
The Hive Hub can be reset by pulling the power cable out and putting it back in again. It will take about 5 minutes to fully reboot and pair to your devices. After the 5 minutes, refresh the app or website.
How do I rejoin my Hive thermostat?
Hold the central heating button down on the receiver until the status light is flashing pink. Release the button and then hold it again until the status light is double flashing amber.
How do I reconnect my Hive thermostat to the Hub?
Hold the central heating button down on the receiver until the status light flashes pink. Release the button then press and hold it again until the status light is double flashing amber. To reconnect the receiver to your hub, put your hub into pairing mode by selecting ‘Install devices’ in the Hive app menu.
How do I reconnect my Hive to my boiler?
Lift your thermostat off the hooks that hold it against the wall and take your thermostat to the receiver which you will find near to your boiler/hot water tank. Remove the batteries and put them straight back in again. This will turn the thermostat off and on which should help establish a connection to the receiver.
How do I reconnect my Hive after changing the battery?
Take out the old batteries and replace with fully charged ones Hive thermostats take four AA batteries. Secure the thermostat back onto the wall mount it should automatically turn back on and reconnect to the system.
Contents