How Do You Remove A Commercial Schlage Lock Cylinder?

How do you remove a commercial door knob without screws or slots?

If you don’t see a screw head inside the slot, straighten a paperclip or grab a thin, pointed tool, such as an awl. Insert the paperclip or tool into the slot as you gently pull the knob away from the door. The paperclip or tool will spring the door mechanism, allowing you to pull out the handles.

How do you change a Schlage door handle?

How to change the handing of your Schlage door lever

1. Locate the pin tool that came with your lock.
2. Insert the tool into the small hole on the lever base and gently depress the retainer pin while pulling the lever away.
3. Remove and exchange both levers.

How do you remove a Schlage door knob without screws?

There should be a small latch near the base of the knob or handle, probably on the exterior side of the door. Push this latch in, and pull the handle off the door. Next, find a small slot on the edge of the trim piece. Insert the tip of a screwdriver and pry off the trim piece.

How do you remove a Schlage lever door handle without screws?

Look for pin holes in the rose or in the lever body itself. Straighten a paper clip and insert it into the hole. Apply a bit of pressure to the paper clip to trigger a release button inside the hardware. Once triggered, the lever or lock trim can be removed from the door.

How do you take apart a Schlage Lock?

How to Remove Schlage Locks

1. Pull the interior handle away from the exterior handle, and set the two handles aside.
2. Insert a screwdriver into one of the holes in the latch mechanism.
3. Remove the screws from the strike plate in the door jamb, and pull the strike plate away.

How do you rekey a lock cylinder?

How to Rekey a Lock

1. Step 1: Remove the Doorknob. The first step is to remove the doorknob from the door.
2. Step 2: Remove the Cylinder.
3. Step 3: Take Out the C-Clip.
4. Step 4: Attach Key Plug.
5. Step 5: Dump the Old Pins.
6. Step 6: Insert New Pins.
7. Step 7: Replace the Plug.
8. Step 8: Reattach Knob to Door.

Can I rekey a Schlage lock myself?

Schlage Rekeying Kits provide everything you need to get the job done—including all the tools and parts you need for repinning the cylinders of most Schlage locksets so that they work with a single key. Navigating your way through the Kit tray.

How much does it cost to rekey a Schlage Lock?

Home Depot will rekey locks such as Schlage, Kwikset, doorknobs, deadbolts, single and double cylinders for $5 to $15 per lock.

How do you remove a Schlage deadbolt screw cover?

The screws are located under those metal “pins” The metal pins are actually screws that have metal caps pushed into them so they look like you can’t unscrew them. Take a very sharp small screw driver and pry under those caps and they will pop off revealing the screw head.

How do you remove a cylinder lock without the key?

Take your screwdriver and insert it into the ignition lock cylinder. Turn it as far round in a clockwise direction that you can. Then pull the paperclip to the right as much as you can. You should then be able to slide the switch out easily.