BATTERY TIP 4 – Never fully discharge a deep cycle
How much can you discharge a deep cycle lead acid battery?
Lead-acid batteries can only be discharged up to 50% before irreversible damage occurs. In practice this means that you will only be able to use half of your battery capacity. Semi-traction batteries such as AGM en Gel lead-batteries are often used as Marine batteries for water sports and angling.
At what voltage is a deep cycle battery discharged?
They’re rated down to an end point of 10.5 volts. By then, lights get dim and TV picture small. A Specific Gravity of about 1.200 or a voltage of 12.25 to 12.3 means the battery is about 50% discharged. By the time it’s down to 11.8 or 12 volts, it’s almost dead.
How much can you discharge an AGM deep cycle battery?
The leading advantages of AGM are a charge that is up to five times faster than the flooded version, and the ability to deep cycle. AGM offers a depth-of-discharge of 80 percent; the flooded, on the other hand, is specified at 50 percent DoD to attain the same cycle life.
How many cycles can a deep cycle battery take?
A battery undergoes a deep cycle whenever more than 20% of its stored energy is consumed before it is recharged. Used correctly, deep cycle batteries can provide 200 to more than 3000 discharge/charge cycles. Starting batteries are not designed for sustained discharge and will last for only 50-60 use cycles.
How do you bring a deep cycle battery back to life?
Fill each of the battery’s cells with distilled water and baking soda solution. Using a funnel, go gently with this approach. Replace the battery caps. For around 30 seconds, shake the battery.
Is 12.3 volts a good battery?
Check the reading. A fully charged battery will typically display a voltmeter reading of about 12.6 to 12.8 volts. If your voltmeter is showing a voltage anywhere between 12.4 and 12.8, that means your battery is in good shape. Any voltage above 12.9 volts is a good indicator that your battery has excessive voltage.
Should you completely discharge a deep cycle battery?
BATTERY TIP 4 – Never fully discharge a deep cycle lead acid battery! The deeper you discharge the battery the more it will reduce the battery’s total cycle life. We recommend discharging a battery to no lower than 50% DOD, with a maximum of 80%.
Can you Desulfate an AGM battery?
Keeping your AGM battery charged during and before storage will help to avoid the process of sulfation. In case sulfation occurs on your AGM battery, use a desulfation charge to reverse the sulfation. You can also use the AGM battery recommended charger to lower the impact of sulfation.
Can you trickle charge a deep cycle battery?
Yes, this is possible with any battery if you are using an older-style simple charger. Use a smart charger to avoid overcharging. Is it OK to trickle charge a deep cycle battery? Trickle charging is the correct way to charge a deep-cycle battery.
How much can you discharge a gel battery?
Battery Discharging Characteristics The rated capacity of Victron AGM and Gel Deep Cycle batteries refers to 20 hour discharge, in other words: a discharge current of 0,05 C. The rated capacity of Victron Tubular Plate Long Life batteries refers to 10 hours discharge.
Can you overcharge a deep cycle battery?
Can you overcharge a deep cycle battery? Yes, the deep cycle batteries can be overcharged. The amps that are used for charging these batteries decide whether the battery will be overcharged or not.
What can over discharging a battery do?
Over discharge may cause difficulties in recharging the cell by increasing the battery’s internal resistance. Also, over discharging may cause lead to be precipitated in the separator and cause a short in the cell or between cells.
What happens if battery is deeply discharged?
When the battery is over-discharged, the internal resistance increases. It discharges 1.5 to 2 times the capacity of the battery making it difficult to recharge them. First of all, you should check the present voltage level of the battery, which is lower than the cut-off voltage.
Can a sulfated battery be saved?
A sulfated battery is the most common malady of a dead battery, but as long as an used lead acid battery is mechanically sound, a sulfated battery can be revived.
Can you load test deep cycle batteries?
When load testing remove all battery cables from their terminals. Using a load tester, apply a 15-second load equivalent to 50% of the battery’s CCA rating. Refer to the load testers minimum passing voltage to determine the battery condition.
How long does it take to Desulfate a battery?
Depending on the size of the battery, the desulfation process can take from 48 hours to weeks to complete. During this period the battery is also trickle charged to continue reducing the amount of lead sulfur in solution.
How do you charge a flooded deep cycle battery?
Fluid on top of a flooded battery may indicate over-watering or overcharging. Fully charge the batteries prior to adding water. Only add water to discharged or partially charged batteries before charging if the plates are exposed. In this case, add just enough water to cover the plates and then charge the batteries.
How many volts should a brand new battery have?
12.6 volts
Fully charged automotive batteries should measure at 12.6 volts or above. When the engine is running, this measurement should be 13.7 to 14.7 volts.
Can you start a car with a 12.3 volts?
When the probes touch the terminals while the car is off and the battery is resting, the multimeter display should show a reading of 12.2 to 12.6 volts (full charge). This voltage range means the battery is in good condition for starting the vehicle.
Is 12.3 V too low?
12.6V volts or above – Your battery is healthy and fully charged. No further action is required. 12.5 volts – Your battery is at a healthy state of charge, but we’d recommend re-checking it within a few days to ensure the voltage hasn’t dropped any further.
Contents