RED LIGHT ON STEADY – Whenever the red light is on steady, a. battery is connected properly and the charger is charging the battery. The red light will remain on until the charger completes the charging stage. < GREEN LIGHT FLASHING –When the green light is flashing, and. [embed]https://www.youtube.com/watch?v=9TPNLE3yAig[/embed]
How do you tell if your battery tender is working?
If the battery is fully charged, then the Battery Tender Plus battery charger’s green light will be on. Once the AC power is removed from the Battery Tender Plus battery charger, the green light will go out and the charger not have any effect on the battery.
What does it mean when a battery tender flashes red and green?
This red-green blinking means you hooked up the battery “polarity” wrong. When hooking up battery to a charger or when jumping from another vehicle you hook the positive to the positive terminal and then the negative to the negative terminal.
What does yellow light on Battery Tender mean?
➢ YELLOW – When the yellow light is on, the battery charger is in the process of fully charging the battery. In order to properly charge large capacity batteries, the charger may remain in this mode for several hours or even days.
What does flashing red on battery tender mean?
➢ RED FLASHING – When the red light is flashing, the AC power is applied to the charger and the microprocessor circuitry is functioning properly. There is no battery connected or there is a problem with the connections between the charger and the battery.
How long does it take for Battery Tender to turn green?
6 to 8 hours
So it will take 6 to 8 hours for the green light to come on. Fortunately, the Battery Tender Plus has the ability to continue to supply its full current even after it has switched over to the lower, float, maintenance charge voltage of 13.2 volts.
Can Battery Tender charge a dead battery?
Therefore, a fully discharged 15 Amp-Hour battery will take approximately 16 hours to recharge to 80% capacity. WORKING WITH A DEAD BATTERY OR A BATTERY WITH A VERY LOW VOLTAGE: If you try to charge a dead battery having a voltage below 3 Volts, the Battery Tender® Junior charger will not start.
Does red or green mean charging?
Red Light ON means Charging is going on. Green Light ON means Fully Charged.
How do you reset a Battery Tender?
To activate the battery simply press the RESET button located at the end of the Quick Disconnect (QDC) charging harness for ONE second, then if the engine fails to start on the first try, a load such as the headlights can be used to warm the battery.
What do the lights on a battery charger mean?
The blinking LED lights indicate different status of charge: Short green flash = less than 80% charged. Long green flash = more than 80% charged. Solid green light = 100% charged. Red flash = fault code, charging error.
Why won’t my Battery Tender charge my battery?
If you try to charge a drained battery, it won’t charge because it has a polarity sensor that needs some minimal voltage (2 volts) to detect the polarity to prevent reversed polarity charging/shorting it.
What is the difference between Battery Tender Jr and Battery Tender Plus?
The Jr is really intended to maintain a good battery (although some folks have used it with success to revive a flat battery). The Plus has the charging schedule and horsepower needed to charge high internal resistance batteries (essentially everything other than a lead-acid).
Can a Battery Tender go bad?
Motorcycle battery tenders do not get weak from use. However, batteries do. On average, a motorcycle battery should last for 48 months. Lack of maintenance on the other hand could cause the battery to go bad faster.
How do I know when my battery is fully charged?
To check the voltage you’ll need a voltmeter, which can be purchased cheaply from most major automotive parts stores. Check the voltage of your battery using the voltmeter to help determine your next course of action. 12.6V volts or above – Your battery is healthy and fully charged.
What color is battery charger when fully charged?
GREEN
When the battery is fully charged, the CHARGE LED will be illuminated GREEN. The CHARGE LED will remain a solid GREEN color (not blinking) until either the battery charger is disconnected or the battery becomes discharged.
Does green Mean charged?
Yes, a blinking green light means it is charging. A rapid blink means the battery is bad. A green light means it is charged.
How much voltage should a Battery Tender put out?
However, most Battery Tender® battery chargers have float voltages between 13.3 and 13.5 volts. The important thing is that the float voltage should be higher than the fully charged rest state battery voltage and it should be lower than the gassing voltage which is about 13.8 volts.
What does red light mean when charging?
Red light means it needs to be charged. Blue light means its charged and can charge your devices.
Why is my charger light red and not green?
Actually when the light on the charger is Red it means not to unplug it because the battery is below 10%. The Orange is when it is still charging but not yet finished. Green is fully charged. Think of traffic lights and signs.
Contents