Putting 48V behind a motor that is designed to run 3500rpm (or whatever it may be) at 36V will, in fact, make her run faster. Swap the motor with the battery bank and controller and you will see no speed increase until you reprogram the controller for higher speeds.
Can you run a 36V motor on 48V?
if you use a 48v controller on the 36v motor, it will run hot and live short.
What’s the difference between a 36 and a 48 volt golf cart?
Basically, a 48V system gives you more “pep in your step” and picks up/speeds up a bit faster than a 36V system. Energy Needed/Amps Drawn- A 48V system draws less amps and provides a little more range with all things being equal (cart/passenger payload weight, motor horsepower, etc).
Will a 36 volt solenoid work on a 48 volt golf cart?
If it’s between 0 to 0.4 ohms, your solenoid is still in good shape. If it’s above that, it’s time for a replacement. Finally, remember to buy a solenoid that’s compatible with the voltage in your golf cart. Usually, that means you’ll need a 36-volt option or a 48-volt option.
How can I make my 48 volt EZ Go golf cart faster?
6 Ways You Can Make a Golf Cart Faster
- Add More Torque to Your Golf Cart.
- Upgrade Your Golf Cart’s Motor.
- Improve the High-Speed Controller of the Cart.
- Add Better Golf Cart Tires.
- Use a Higher Powered Golf Cart Battery.
- Watch the Weight in Your Golf Cart.
Can a 36V controller handle 48V?
Most 36V controllers will support a 48V pack, but the LVC will still be set for a 36V pack, so you’ll need to monitor pack voltage and not let it get too low. You can verify this by opening the controller and checking the caps and fets. If it has 63V main caps it should be fine.
Can you use 48V battery with 350W motor?
Re: 48v battery on 350W ezee motor
Depends on how many watts your lyen controller is going to allow into your 350 motor. I’d say 20 amps would be about the most you’d want to put on it. 1000w. Bear in mind, that doesn’t mean you will pull 1000w, 20 mph travel should still take the usual 400-500w unless climbing hills.
Is 48V better than 36V?
It is pretty simple to understand. A 36V e-bike battery will allow you to draw a lesser critical current, typically around 15 amperes whereas, a 48V e-bike battery will allow more current in the range of 10 – 40 amperes. It means you can go faster with a 48V E-bike battery.
How far should a 36V golf cart go?
A 36 volt golf cart is adequate for 2 to 4 passenger use when you are primarily using it on flat a flat surface. The average drive time or range for a 36 volt DC system is about 30 miles on a full charge.
How can you tell a 36V from a 48V?
Determining how many volts your golf cart uses is as easy as counting the water fill caps on all of your batteries. If you have six 6 volt batteries your golf cart is a 36 volt cart, if you have six 8 volt batteries or four 12 volt batteries your golf cart is a 48 volt cart.
How do you test a 36v golf cart solenoid?
Set your multimeter to ohms and insert a probe on each large terminal with the key off and the cart direction switch in the neutral position. Press on the accelerator with the cart’s movement control in the forward position, and the key is turned on. A click should be heard first from the solenoid.
Why is my electric golf cart jerking?
The most common reason for your golf cart jerking is often the battery terminal connections are loose and/or corroded. A poor connection prevents the correct amount of current from flowing through the set of batteries to your speed controller (or resistor coil), and ultimately to your electric motor.
How do you test a 36 volt ezgo solenoid?
This can Also be tested by putting a test lead on each small terminal and pressing the gas pedal. The meter should read 36 V when the gas is pressed. If this voltage does exist when the gas pedal is pressed then the solenoid should click and engage.
Is 30 mph fast for a golf cart?
Depending on how far you want to go on a full charge, you might want a 40mph or a 30mph golf cart. At top speed, most golf carts do around 14mph. However, with the advent of street legal golf carts and modifications, it is possible to go 35mph and above.
How can I make my 36V golf cart go faster?
How to Make a 36 Volt Golf Cart Faster
- Remove any unnecessary additions, racks or parts on your golf cart.
- Power-wash your cart.
- Check the shaft under the ignition pedal.
- Put larger tires on the cart.
- Replace any old or worn-out parts that are causing the cart to move slower than it should.
How fast is a 72 volt golf cart?
Specs
| Express S2 | |
|---|---|
| VEHICLE LOAD CAPACITY | 500 lb (227 kg) |
| TURNING RADIUS | 11.0 ft (3.4 m) |
| OUTSIDE CLEARANCE CIRCLE | 22 ft (6.7 m) |
| SPEED (LEVEL GROUND) | 19 mph (31 kph) max |
Can you charge a 48V battery with a 36v charger?
Generally speaking, yes, yes it will. No matter what kind of battery you’re charging, if you hook up a 36v battery to a 48v charger and let it charge to completion, you’re going to ruin your battery.
How fast is 36v in mph?
Kids electric cars using 36v batteries are capable of significantly higher speeds than smaller models, since they are able to use larger, more efficient motors. Some 36v vehicles can travel at speeds of 15mph. 48v vehicles are capable of even greater speeds, topping out at around 18mph.
How long does a 36 volt ebike battery last?
For example, a 36v 10ah battery pack with 360 wh of capacity. (36 volts times 10 amp hours equals 360 watt hours). This pack would in theory provide 36 km of range, or 22 miles, from a full 100% charge.
Can you put 48V batteries in a 36V golf cart?
It all depends on your battery bank used with this 36V to 48V conversion. can only be accomplished through installing a 48V motor capable of higher torque, or installing a 48V controller with a higher current limit (amperage). When DC power is discussed, amperage equals torque and voltage equals speed.
Can I run a 24V motor on 36V?
Your 36V wheel would not even START to spin with a 24V power source and controller attached, even though the microcontroller would be very much alive. The way this is accomplished isn’t sublte. The same controller board is used in systems from 24V through 48V, from what I’ve had my ands on.
Contents