How tight should tent pole shock cord be?
Tie a simple binding knot about 2″ from the end and tighten. Your peg should now be between the knot and the long end of the cord. Feed the other end of the cord (the long end) into the first section of pole and continue until all sections are on the cord.
What is shock cord used for?
Transportation: as I’ve already mentioned, shock cord is definitely the cord to use when moving things. It absorbs shock from bumps while driving down the road so your precious possessions won’t move around and break on you. Or fly out of your truck and smash to pieces when you’re going 80 mph down the interstate.
How do you remove a ferrule from a tent pole?
Jam the pole in a vice and heat the tip of the ferrule with a heat gun,grasping the ferrule as it is heat with pliers turn it to see if it starts to move. Care must be taken not to over heat as you will burn the pole.
Can you cut fiberglass tent pole?
When cutting the section to length, always cut towards the centre to avoid splintering the edge when you cut through. Cut part way through the pole, then turn it and cut part way. Repeat until you cut right through. Once you’ve cut all the replacement sections for one pole, fit them before moving on to the next pole.
Why do my tent poles keep breaking?
A broken tent pole is a painful, but relatively common camping mishap. Causes range from strong winds to poles weakened by age to cheap materials—and sometimes, it’s just plain old wear and tear.
Can I fix a tent pole?
Using a Pole Repair Sleeve
Also called a splint, this short tube is often provided with your tent.Using a repair sleeve to fix a broken tent pole is simple: Line up the broken pole sections. If the pole is bent but not fully broken, gently straighten out the bend.
Can tent poles be cut?
Mark the length of the old pole next to the new pole. Hold the new pole firmly and very slowly cut the pole to size making sure not to tear the fibers .
How do you measure the length of a tent pole?
1 Answer
- Stake the tent out. Any old stakes will do.
- With a semi-rigid pole (see below) push this pole through the loops/guides until it is taut.
- Mark and measure.
- Once you measure you can order poles from any of a number of sites that sell custom poles.
How long should a shock cord be on a tent pole?
1. Cut a new length of shock cord that is 70% the length of your pole. We recommend heating the ends of the cord to seal them so that the cord won’t fray inside your pole.
How much does it cost to stretch a shock cord for a tent pole?
You will need 1/8” thick shock cord and about 1-2 ft. longer than the length of the entire pole for each pole (if you have a 10ft pole get about 12ft, some say a ¾ 1. ratio might be better). Remove the end tip, and the shock cord will be tied in a knot (either on a washer or on the end tip of the pole).