As long as your rough boards are fairly straight, you can send them through the planer taking alternating light passes on each side. Once both faces are clean, they should be flat and mostly parallel. Of course your edges will still be rough.
Can you use a planer on both sides?
Once you’ve flattened one side, you can flip the work and run it through the planer with the flat side down (no sled required) to flatten the other side and ensure that it’s parallel to the first side.
Can you plane one side of a board?
The best solution is a jointer: Joint one surface of any board flat and straight, send that board through the planer—flat face down on the bed—and a beautiful workpiece rolls out the other side, with two, flat, straight, smooth, parallel faces.-wide jointer that can keep up with your planer, or maybe even a 12-in.
Can you plane sides of wood?
Second, by flattening dry, rough-sawn wood, you’ll end up with boards that are perfectly flat, straight and true, which is rare with store-bought boards. It takes an investment to flatten wood, though. You can’t pull this off without a jointer, surface planer and table saw.
How do you make boards thickness the same?
Collect all the boards I want to do at once and work one side at a time. Passing them all through at the same thickness. Lower the height and repeat until I am happy with the results. This can mean that I am passing boards that are not getting cut at every pass.
Will a planer flatten a board?
In order to flatten a warped, twisted, or cupped board, a common approach is to first use a jointer to create one perfectly flat face. Then you run the board through a thickness planer with the flat face downward, and the planer makes the top face parallel to the bottom.
Can I plane plywood edges?
A block plane might work but you’re going to have a very tough time taking down 1cm of wood over such a long length. If you do use a plane, go in small increments and make sure you keep your blade as sharp as possible. A belt sander will work better, provided you use 40 or 60 grit sandpaper.
Can you plane wood with a table saw?
When surface or thickness planing wood for a project, the end product needs to be as clean and straight as possible. When working with wood, it has a tendency to move, warp, and bend as the tension is released from the material.
Can a planer remove cupping?
It is difficult to flatten a cupped board with a thickness planer because the downward pressure of the feed rolls will press out much of the cup, thereby not allowing the planer knives to flatten the board.
Where should you stand while planing a board?
Feed lumber into the planer with the grain of the wood. 7. When feeding material into the machine, stand to he side nearest the switch. Never stand behind a piece of lumber being planed, as kickbacks can cause serious injury.
Can you plane a bowed board?
Mark the shim locations, remove the board and hot glue the shims into place. Then glue the board to the shims and the plywood with a dab of hot glue. Send that rascal through until it’s flat, then pull it free and plane down the other side.
Which face should be jointed first?
That’s why it’s important to joint one face first: Without a flat face to ride against the planer tables, the feed rollers simply press the board flat against the tables while the knives plane the top face. Any cup, bow, or twist springs back once the board exits the planer.
Do you really need a planer?
The thickness planer is not the most versatile tool in your arsenal. In fact, it really only does one thing: it planes things to a consistent thickness, as its name suggests. It’s definitely not a tool you wanna buy before a compound miter saw, or even a table saw.
Is a wood planer necessary?
Most woodworkers know that you need both a planer and a jointer to get the most out of rough lumber (at least for power tool users). The jointer is used to flatten one face and square up one edge and the planer is then used to make the second face flat and parallel to the first.
Contents