If you need to go deeper, just let out some backing until your target depth is reached. On the lure end of the line, remove a short section of lead as before and tie on a size 18, or smaller, barrel swivel. Now use a 10 to 15 foot mono or fluorocarbon leader to tie on the lure.
How do you troll at a certain depth?
There are two ways you can determine the exact depth/lure/speed relationship of a specific rig. The first is to deploy it to a specific distance, then troll up a gradual shelf or edge until it starts dragging bottom. Note the depth, and try to crank it in before it snags.
How far behind a boat should you troll?
For bigeye use a flatline about 40 feet behind the boat. They want it in the prop wash. The longer the lures are the more careful you have to be when making turns. You also have to make sure your lures are running straight or you will get nasty tangles.
How do you control crankbait depth?
Move your crankbait too slow or too fast and it’ll run too shallow. The bill has to bite into the water at the correct angle for the lure to run as deep as possible. The length of your cast is the next thing that affects running depth. A longer cast will let the bait get down deeper.
What is the best speed for trolling?
So, what is the best trolling speed? The best trolling speed depends on several factors including the type of fish, water conditions and lure choice. In general, trolling speeds between 1.5 and 2.5 mph, as measured by GPS, are a good starting place for most species like walleye, trout and salmon.
How do you know how deep you are fishing?
Attach a float to your line and a weight where you would normally put the hook. Let it sink and the bobber will give you an idea of how deep the water is. If it’s too deep, it will pull the bobber under and you will need to put more line between the float and the weight.
Can you troll without a trolling motor?
If you don’t have a trolling motor to cruise dock lines and mangroves, you can always troll the edges of channels and flats for trout, ladyfish, jacks, bluefish, and mackerel. And once you find a spot with a lot of fish, you can anchor up or drift.
Is mono or braid better for trolling?
Mono holds knots better and costs less than braid. It also works better on smaller bait-casting reels because light braid can dig into itself. Florida sailfish and dolphin anglers still use a lot of mono on the troll, and some use it for kite lines because it runs through the clips better.
How do you slow down a boat while trolling?
Shut Down Your Boat’s Engine(s)
With triple outboards, for example, shutting down the center engine (or leaving it in neutral) will help you troll slower. If that’s not slow enough, use just the center outboard and turn off the two outside motors. With quad outboards, try running just two motors.
How deep will walleye go?
Walleye are generally caught between 10-40 Ft. A typical mid-sized lake in the Midwest would likely hold Walleye between the depths of 10-15 Ft. during the Spring, 15-25 Ft. transitioning to Summer, 25-40 Ft.
Can you troll with a crankbait?
When trolling crankbaits, use a bait casting reel and a medium heavy rod, six to seven feet in length. I prefer to use Magnathin in the ten-pound test (walleye color). The new superlines will also work. Longlining crankbaits is a very simple technique that will produce fish.
Should you troll with or against the current?
When in an area with current, troll crosscurrent as opposed to with and/or against the current. Going crosscurrent, you don’t have to worry about how the current is affecting your lure’s or bait’s speed through the water. Plus, fish generally swim into the current.
Can I troll with a spinning rod?
Yes, trolling offshore for species like tuna and mahi can be done with a spinning reel—if you know a few basic facts. Naturally, when offshore trolling you wouldn’t want to use a reel, even a high-quality reel, that’s sized for stripers—like a Shimano Stradic C3000. This is a great reel, but it’s simply not big enough.
Can you troll a Rippin Rap?
Rippin’ Raps.
“You can cast and retrieve, or you can cast them out, let them sink to the bottom, pop them off the bottom, and repeat. That popping off the bottom can really get some violent strikes from walleyes, or a lot of other species, too. “You can fish them around weeds, rocks, really any cover.”
How do you catch walleye in muddy water?
5 Tips for Dirty-Water Walleyes
- Find the Clearest Water. Dirty water proceeds in stages.
- Jazz Up the Bait. Presenting a bait or lure to walleyes is more difficult when there’s low visibility.
- Cover More area.
- Be Ready To Strike.
- Fish Shallower.
Why are trolling rods so long?
Trolling rod length
The reason for the extra length is that it allows you to troll with several poles at the same time, without getting their lines tangled. You can achieve this by extending a long trolling pole to the right and the left of the boat, so their lines will be separated maximally.
Contents